The A is a sophisticated microprocessor controlled dual channel power meter which can measure ratio and A HP Manual was downloaded from the Web. HP A Power Meter is a dual channel power meter designed specifically for ATE systems. The compact front panel is designed to save space in rack mounted. The HP A Power Meter is a dual channel power meter designed specifically for ATE systems. . Option Additional manual. Option W Two additional.
|Published (Last):||1 January 2010|
|PDF File Size:||15.26 Mb|
|ePub File Size:||8.82 Mb|
|Price:||Free* [*Free Regsitration Required]|
Display with no sensors connected. Switch off Power Ref, check Oscillator light is off. The A has a 3V 0.
A Dual Sensor Power Meter [Obsolete] | Keysight (formerly Agilent’s Electronic Measurement)
Up to 19 different operating states of the meter mznual be stored into non-volatile memory for later recall. The power reference output and calibration controls are used to calibrate the particular power sensor in use.
It measures absolute power in Watts or dBm, and relative power in dB. All measurement modes are programmable including zeroing, calibration, and Cal Factor. The battery maintains the supply voltage to the RAM.
The AUTO filter mode 483a usually adequate for fully settled readings with 0. Initial display lights all segments. A HP Manual was downloaded from the Web.
View Cart My Account. The compact front panel is designed to save space in rack mounted systems, while the dual channel design allows simple measurements of the ratio and difference of power levels from two separate sensors.
Press Zero key and wait for routine. The programmable digital averaging filter gives the user control over the inherent tradeoff between speed and accuracy.
Providing the finest test equipment solutions since 1992
January A Quick Calibration Procedure: Disconnect Sensor from Power Ref output. Up to 19 different operating states of the meter can be stored into non-volatile memory for later recall.
Rear Panel Sensor Connector and additional reference oscillator with rear panel output. Welcome to Azur Electronics. Top view with cover removed. Compatible with the HP series of thermocouple and diode sensors, the power and frequency range of the meter extends from dBm to 44 dBm and from kHz to 50 GHz.
Recommended for use with the Series Power Sensors. Important measurement contributions are a programmable digital filter for optimizing resolution and measurement speed, independent offset in dB values for each channel, 0.
Complete interrupt capability with flexible SRQ operation optimizes the efficiency of program execution in automatic systems.
Bottom view with cover removed. Top PCB hinges up.
HP A Power Meter
I use this as my ‘reference’ power meter. November Checking all the specialist batteries in my test equipment, see Batteries In Test Equipment. The A needs powering up occasionally to recharge the 4438a. Less digital averaging leads to faster but noisier readings if speed is the critical issue. Initial power up display. The A is a sophisticated microprocessor controlled dual channel power meter which can measure ratio and difference of power levels from 2 different sources.